So I had to dremmel a place for it to go
Looks like it’s going to work perfectly.
More to come…..
Looks like it’s going to work perfectly.
More to come…..
Now for the perverted twist –
Posted 09-07-2009 at 06:50 PM by Gil Kane
“HIGH BEAMS”!!!
Take a straight pin and heat it up, then melt a hole for the nip
(meowfuckingowch!!!)
Then using wire cutters cut off the top of two pins
Insert the cut pins into the holes
More to come…..
Take a straight pin and heat it up, then melt a hole for the nip
(meowfuckingowch!!!)
Then using wire cutters cut off the top of two pins
Insert the cut pins into the holes
More to come…..
Total Comments 0
